SCREW RETAINED

SURCAM's unique Multi-Unit system provides a solution for screw-retained prostheses. Surcam designed the system to provide a solution for multiple tilted implants cases that are complicated to restore. The Multi-Unit system provides a superior prosthetic solutions and covers a full range of sizes for both the upper and lower jaws: This low profile system comes in different angels: a straight adapter, 9°, 18°, 30° and 45° angle adapters, in a variety of gingival heights. The system also contains all the significant complementary products needed.

MULTI-UNIT RESTORATION
Screw retained restoration

1. Straight Multi-Unit - an abutment connection to an implant can be mounted at six different heights:

1. Premiun straight Multi-Unit with hex - an abutment connection to an implant can be mounted at six different heights:

_______________________________________________________________________________________________________________________________________________________________________________________________

2. 18° and 30° Angled Multi-Unit abutments are available in three different heights: H00, H01, H02

__________________________________________________________________________________________________________________________________________________________________________________________________

__________________________________________________________________________________________________________________________________________________________________________________________________

5. Angle and height clip gauge - use the Gauge Kit for angle and height selection

Using the angle gauges gives you an option to pre-plan the use of the abutment in order to achieve maximum parallelism.

__________________________________________________________________________________________________________________________________________________________________________________________________

6. Multi-Unit connection - use the holder to place the base connection into the implant
Multi-Unit abutments attached to the implant

Closed tray impression coping - with plastic cap

__________________________________________________________________________________________________________________________________________________________________________________________________

Snap-on to secure positioning & Use Closed-tray impression coping

connect the transfer onto the abutment. Inject impression material and position the impression tray
Inject impression material and position the impression tray. Send the impression tray to the laboratory

__________________________________________________________________________________________________________________________________________________________________________________________________

In cases when a two-stage surgery is indicated:

Healing procedure - connect the temporary restoration healing cap
The original denture can be used on top of the healing caps while the temporary denture is being produced

__________________________________________________________________________________________________________________________________________________________________________________________________

Connection of the temporary prosthetic restoration - verify tightening of 15 Ncm

The screw geometry was carefully designed and optimized to allow safe tightening and long service. Special attention must be paid while tightening the screw. Make sure to use an original SURCAM hex key with edges that do not show wear. It is recommended to purchase additional screws

__________________________________________________________________________________________________________________________________________________________________________________________________

Simple immediate restoration implantation
The sleeves height needs to be trimmed to the desired height